The use of Bricks or Pavers to develop a pathway or patio matches a house in a way that is unmatched. In addition, setting up a Brick or Paver pathway does not always require a pro.
The secret to setting up a Brick or Paver Walkway is to very first effectively prepare the location where the bricks/pavers are to be set up. The location must be dug out at least a foot down, removing all topsoil and clay soil. In addition, string lines ought to be strung on each side of the walkway. The string lines show the completed height of the walkway.
As soon as the area has actually been dug down, 3/4" gravel stone ought to be laid in and tamped down securely. The height between the tamped down sand and the stringline need to equal the density of the brick or paver.
Now that you have a stable base, place a 1" pipe or ledger board the length of the walkway on either side of the sidewalk. Then using a flatedge, e.g. a 2"x4" board, slide it over the 2 lengths of the pipe/ledger board. In doing this you will develop a level surface location to lay the bricks/pavers.
Now location on the level sand/stone dust strips of plastic brick borders. Install a work on both sides of the prepared location. These strips will serve as your pathway border and help to preserve the integrity and shape of the sidewalk. You can get these plastic strip borders at a lot of house improvement shops. The strips should be anchored down with 12" galvinized nails. You must sink these nails into the ground and through the strips every foot.
The secret to laying the bricks/pavers is to make sure that they interlock with each other. Constantly stagger adjacent rows of bricks by 1/2 of a brick to interlock them. This will once again help preserve the stability of the sidewalk.
Undoubtedly bricks/pavers will require to be cut or split when developing the pathway. Unless you desire to buy or rent an expensive wetsaw, I would suggest buying a simple brick/paver splitter. It is basically a sculpt with a broad end that is the width of the bricks/pavers. To actually cut/split the brick/paver, lay it in a bed of sand and place the sculpt at a 75 degree angle over the area where you wish to break the brick. Then using a hammer strike the butt end of the sculpt strongly. You may require to do this a couple of times. You may likewise desire to turn the brick/paver over and strike the other side of the brick using the hammer and chisle. Within one or 2 strikes the brick/paver need to break read more easily. , if your walkway has curves you will require to buy/rent a wetsaw.
.
After setting up the bricks, develop the outdoors edges with additional sand, and after that shovel in the topsoil and pack down firmly.
Spread stone dust over the new sidewalk and sweep into the cracks. This will finish the interlocking of the bricks and help to remove any weed growth.
In addition, setting up a Brick or Paver walkway does not always require a pro. The secret to setting up a Brick or Paver Walkway is to first properly prepare the area where the bricks/pavers are to be set up. Now that you have a stable base, position a 1" pipe or ledger board the length of the sidewalk on either side of the walkway. These strips will act as your sidewalk border and help to preserve the stability and shape of the walkway. Inevitably bricks/pavers will require to be cut or split when developing the sidewalk.